Metal cutting discs made of glass fiber and resin bonding material reinforced with high tensile, impact and flexural strength, widely used in ordinary steel, stainless steel and non-metallic materials production, the excellent material, exquisite craftsmanship ensures high cutting efficiency for different workpiece materials and the best economic results. Cut pieces belonging wheel, abrasive and binder resin made for ordinary steel, stainless steel sheet metal and nonmetal materials.
2016年1月9日星期六
Tile cutting disc you can cut glass
No,cutting discs has high tensile, impact and flexural strength. Because the cutting disc own characteristics, easy to use cut pieces chopped glass, cut glass using a glass cutter.
Glasscutter here refers to a tool used to cut glass. Section usually glass cutter for cutting glass hardness greater than diamond or alloy material.
Cut glass technique
First, use a glass cutter cut 2-3mm thick plate glass
Cutting 2 a 3m-thick plate glass available 2mm × 12mm thin wooden ruler, the first amount of glass the size of the ruler fix cut size, consider leaving neutral and 2mm 3mm incision. Cutting may have a size of one side against the side of the glass. Glasscutter close to the other end of the straightedge, grasp the blade end straight draw back, you can not have the severity of bending.
Second, with a glass cutter cut 4-6mm thick glass
4-6mm thick glass cutting method is generally the same as above, but the glass is thick, cutting to hold accurate, predict with confidence, forced the severity uniform. Another cutting method is to use 4mm × 50mm ruler, cut glass cutter against ruler. When cut, the cut in the mouth to brush up on some kerosene in advance, so that after nicking permeability easy to pull off.
Third, use a glass cutter cut 5-6mm thick chunks of glass
5-6mm thick chunks of cut glass and cutting the same method with 5mm × 40mm ruler. But the larger chunk of glass, people stand on the ground can not be cut, and sometimes need to stand on the glass cutting, you must pad flannel on the bench before cutting the glass under pressure even after cutting the glass with both hands required, while down plate off, not careless, resulting piece of glass breakage.
Fourth, glass cutter cutting wire glass
Wired glass cutting method with 5 a 6mm plate glass, wire glass cutting surface but rugged, cutting edge slippery, difficult to master, so to understand the blade, hold steady head, forced glass bigger than the average speed but also faster, so as not to appear bent not straight. After cutting the glass with both hands pull down firmly, clip wire can dial off, then use pliers to clamp the wire cut down, so as not to cut through the palm when handling.
Fifth, cut by a glass embossed glass
Embossed with a glass cutter glass cutting, embossing surface should be at the cutting wire glass with the same methods.
Six, with frosted glass cut glass cutter
With frosted glass cutter cutting, rough surface should be lower, and flat glass cutting method is also the same.
订阅:
博文评论 (Atom)
没有评论:
发表评论