2016年1月1日星期五

Resin-cutting storage and use precautions:


1, cutting discs handling must be handled with care to prevent the collision entire crack!
2, cutting disc should be stored moisture, antifreeze, anti-deformation, cut pieces on a wooden pallet should paperback or wooden plate, stack height does not exceed the value of the general!
3, resin-cutting storage time of one year, over the time the rotation should be re-tested to confirm compliance before using!
4, the installation angle to the cutting blades mill, require contact with the cutting disc flange surface clean and smooth, elastic moderate tightening requirements for cutting films, only allowed to use special wrench reinforcement, prohibit the use of supplementary fixtures to prevent abrasive man-made damage!
5, the cutting speed can not exceed the work piece using line speed cutting sheet under the trademark when using pneumatic grinding machine, to prevent pressure instability, resulting in cut sheet exceed the maximum speed!
6, the use of films to be slowly cutting into force, excessive force prone to stall, stuck and crashed cutting discs phenomenon, the event should be immediately cut the jammed sheet filed to avoid cutting discs burned out or broken card!
7, cutting discs only allow monolithic installation, it is strictly prohibited two or more than two simultaneous installation!
8, resin-cutting is only allowed for cutting, are not allowed for grinding!
9, cutting slices using equipment shall comply with the provisions of grinding machinery safety regulations!
10, users in the use of abrasive cutting discs are in compliance with safety rules!

没有评论:

发表评论