Wheel storage and use of

Abrasive storage location should be chosen smooth and relatively dry place, room temperature should not fall below 5 ℃. Wheel should stand on the shelf is appropriate, do not pile up too high, so as not to crush and collapse. Wheel certificate and signs must be placed along the wheel together, to prevent confusion.
Rubber and resin sheet wheel, stack height should not exceed 160mm, and should be caught in the middle of a flat iron Guanghua, should pressure above a certain load, to prevent deformation of the tile cutting disc.
Resins and soft rubber wheel storage for more than one year shall strength test before re-use.
Wheel in the process of moving, non-scrolling, should be handled with care to prevent vibration and shock caused by a crack, Obscure, fragmentation, and so out of the side to try to ensure safety.
Wheel check carefully before installation, and struck with a wooden hammer wheel, depending on when it is installed to a grinder or stainless steel cutting discs flange tightening applications. Two flange outer dimensions must be the same.
Are there cracks or unusual sounds. Found an outer diameter of 150 mm and larger wheel mounted on the flange should be balanced after-hours, and then install the grinder to be corrected, amended should be balanced again before you can use the wheel cracked and hoarse voice, it is strictly prohibited to install grinder or grinder.