Grinding wheel is a cutting tool, which consists of many small and hard, abrasive and adhesive binders from the porous body. Abrasive cutting directly responsible for the work, sharp and must have a high hardness, heat resistance and a certain toughness. Commonly used abrasive alumina (also known as corundum) and silicon carbide two kinds. Alumina-based abrasive, high hardness, good toughness, suitable for grinding steel material. Type silicon carbide abrasive hardness higher, sharper, good thermal conductivity, but more brittle, suitable for grinding cast iron and tungsten carbide.
For the same stainless steel cutting wheel, because of its different thickness, surface roughness and processing efficiency is not the same after the workpiece, coarse grains for rough grinding, fine abrasive grains, the more rough abrasive grain size number smaller. Pengxiang Linyi Junan Abrasives Co., Ltd. is well-known wheel manufacturer, the production of the wheel, grinding wheel, get the praise of new and old customers!
Binding agents from bonded abrasive effect. Commonly used ceramic binders, followed by the resin binder. Different binders choice of materials, the impact wheel corrosion resistance, strength, heat resistance and toughness.
The more firmly bonded abrasive particles, the more difficult to fall from the wheel, the hardness of the wheel is said that the hardness of the wheel is the degree of difficulty of the diamond cutting discs surface under loads off. Easy to fall off called soft, otherwise known as hard. The abrasive grinding wheel hardness and hardness are two different concepts. Surface grinding of the workpiece is relatively soft, abrasive cutting edge (corner) on easy to wear, this time may be longer use abrasive, that some of the firm bonding optional wheels (high hardness of the wheel). Conversely, a low hardness grinding wheel for high hardness workpiece.
Job wheel at high speed, in order to ensure safety, should be checked before installation, there should be no cracks and other defects; in order to make the wheel steady, balancing test should be carried out before use.
After a certain time of the grinding wheel, the surface voids are clogged debris, abrasive acute angle will be blunt, the original geometry will be distorted. It must be trimmed in order to restore the cutting ability and the correct geometry. Required diamond grinding wheel dressing pen.
Metal cutting discs made of glass fiber and resin bonding material reinforced with high tensile, impact and flexural strength, widely used in ordinary steel, stainless steel and non-metallic materials production, the excellent material, exquisite craftsmanship ensures high cutting efficiency for different workpiece materials and the best economic results. Cut pieces belonging wheel, abrasive and binder resin made for ordinary steel, stainless steel sheet metal and nonmetal materials.
没有评论:
发表评论